Shop

13080 artikel gefunden.

RESET

Engine flywheel in exchange

Org. Art.-Nr: 99440518-AT

LT-Art.-Nr: 1017075

CHF 257.00

If the flywheel can no longer be reworked to a minimum dimension of less than 71.9mm, the customer will be invoiced for the difference of 1671.00 between the replacement part and the new part!

Secondhand

Engine flywheel single clutch

Org. Art.-Nr: 99440518-LT

LT-Art.-Nr: 1015023

CHF 2,000.00

Fitting pin 9x16mm

Org. Art.-Nr: 5125535

LT-Art.-Nr: 1002948

CHF 9.55

Nominal diameter: 9 mm
Length: 16 mm

Bending bar support 90/94/L/35/TL/T5000

Org. Art.-Nr: 00000030-LT

LT-Art.-Nr: 1016024

CHF 275.00

incl.4 screws M16x1.5x130

Suitable for:
55-90 60-90 65-90 70-90 80-90
60-94 65-94 72-94 82-94 88-94
L60 L65 L75 L85 L95
TL70 TL80 TL90 TL100
T5030 T5040 T5050 T5060 T5070

Working headlight right 94x154mm Cobo

Org. Art.-Nr: 5182602

LT-Art.-Nr: 1008396

CHF 125.55

Protective cap for 3 switches 60x85mm

Org. Art.-Nr: 5169088

LT-Art.-Nr: 1007470

CHF 34.95

Dieser Artikel wird Kundenspezifisch bestellt und kann nicht Retour gegeben werden !

Top Gasket Set 8045.06 Ø100mm

Org. Art.-Nr: 1940124

LT-Art.-Nr: 1000472

CHF 453.25

Alto mark on the head gasket upwards.
The required tightening torques of the cylinder head bolts must be carried out in three stages when the engine is cold.
Thread and screw head surface slightly oiled.

Tightening torque of the cylinder head bolts M12x1.25x122.5mm
1 Pre-stage 60Nm
2 Check 60Nm
3 90° angular degrees
4 90° degrees
Spiral from the inside to the outside !
Cylinder head does not need to be retightened later !