CHF 35.35
CHF 35.35
excl. VAT
Available: 5.0 Units
This combination does not exist.
Units of Measure: Units
Add to basket
Product information:
Product information:
Spray can with 2-component technology, primer filler and hardener in one spray can.
Properties:
-You receive a solvent and petrol resistant surface!
-High coverage
-High-quality 2-component primer filler
-High coverage, quick-drying
-Professional spray can with wide-jet spray head (spray pattern similar to spray gun) enables fine and perfect atomisation
-Professional priming and filling in a single operation
-Universally applicable 2-component epoxy primer filler for all problematic substrates, e.g. metal, non-ferrous metal, galvanised sheet steel or anodised aluminium surfaces.
Excellent adhesion and corrosion protection properties, even on the most critical substrates, e.g. aluminium
Long processing time: approx. 4 working days at 20°C
-Perfect insulating effect, especially against infiltration by water
Can be recoated with all common paint systems after 20 minutes
Can be ploughed over with 2K polyester materials (after 12h / 20°C or after 20 min / infrared device)
Technical information:
Well-preserved factory or old paintwork must be sanded.
Sand, clean and prime the substrate!
The hardener contained in the can is only released at the touch of a button. At this point, the chemical reaction between the primer filler and hardener begins.
Shake can thoroughly for 2 minutes before releasing
Remove the red push button from the cap. Turn can
by 180° and place the push button on the pin in the base of the can.
Place the can with the cap upside down on a firm surface.
upside down. Press the red release button with the heel of your hand
(colour and primer filler mix)
Shake can again thoroughly for 2 minutes after release.
Test the compatibility with the substrate by spraying.
Apply the primer filler in 2-3 sprays with approx. 10-15 minutes intermediate drying time.
intermediate drying time.
Spray distance 15-20cm
If necessary, sand dry or wet by hand with grit size P400 P500 P800
Recoating possible after 15 minutes to 12 hours without re-sanding
Coverage per can 0.5-1M²
For longer breaks, spray can upside down to rinse out paint residues)
Depending on the temperature and time, chemical bonding then takes place inside and
(processing time approx. 4 days at 20°)
Checkout
