Clutch complete LUK 12" Reinforced 40x45-16 teeth

Attention:
Transmission input shafts from Fiat 880 880-5 980 have been installed which are not within the tolerances of LUK.
Clutch disc jams on profile.
Tolerances according to Luk = 40.00-40.16 /44.75-45.00
If this problem occurs, the shaft must be replaced according to the tolerances or the outside must be turned down to 44.75 or ground.
This problem was unknown with the previous OMG clutches!

Is not included in the scope of delivery:
6pcs. screws 1001379
6 spring washers 1001609

Outside diameter inch: 12 "

Reinforced version with 7 friction linings 8300N
Cerasinter - lining
40x45-16 teeth
Outer centre 361mm
6 hole 11mm pitch circle 335mm
Flywheel friction surface must be 0.5mm higher than bolt surface
Rocker arm height travel clutch 102.5-103.5mm on bolt face
PTO clutch 136.5- 137.5mm on bolt face
Disengagement travel of travel clutch 9.5mm
Disengagement travel of PTO clutch 8mm