CHF 137.70
CHF 137.70
excl. VAT
Available: 6.0 Units
This combination does not exist.
Units of Measure: Units
Add to basket
Product information:
Position sensor for rear synchroniser and group lever position sensor
(green connector with diagnostic function )
Front synchroniser and gear position sensor
AFFECTED MODELS:
T4020, T4030, T4040, T4050 T4030F, T4040F, T4050F
TN60A, TN70A, TN75A, TN85A, TN95A
TN60DA, TN70DA, TN75DA, TN85DA, TN95DA
TN60SA, TN70SA, TN75SA, TN85SA
TN60VA, TN70VA, TN75VA, TN95VA
TN70NA, TN75NA, TN95NA
TN75FA, TN85FA, TN95FA
EQUIPPED WITH DUAL COMMAND GEARBOXES
GEAR AND GROUP SELECTOR STATUS SWITCH SPACING (87585979/87585980)
The lights on the Dual Command Hi/Lo gearboxes may illuminate alternately.
This problem is caused by the gear lever activating the status switches when selecting the gear or group.
group activates the status switches. This is caused by insufficient distance between the pins
of the status switches and the gear or group selector lever.
As an interim solution, two copper washers (part number: 10280060) are placed
are fitted between the status switches and the gear lever cover and replace the original gasket with rubber insert (5169544).
This was introduced into production from the following serial numbers:
Series 4000: Z7JA01001 (from the first production).
Series TNA (STD), TNDA, TNSA: HJE108387
Series TNNA, TNVA: HJB108336
Series TNFA: HJU108354
The two built-in copper washers provide the required additional clearance.
As a final solution, improved shift covers for gear and
group selection have been introduced into production from the following serial numbers:
4000 series: Z8JA08719
Series 4000F: Z8JD08701 (from the first production)
Series TNA (STD), TNDA, TNSA: HJE117767
Series TNNA, TNVA: HJB117675
Series TNFA: HJU117676
On the new gearshift covers (87747940/87747943) the seats of the status switches have been made 1.5 mm deeper.
(Greater material thickness for the threaded holes).
This measure ensures the necessary distance between the pins of the status switches when selecting a gear or group.
distance between the pins of the status switches.
For machines before the listed serial numbers with the intermediate solution applies:
If the dual-command Hi/Lo gearbox lights come on alternately, it is recommended to
it is recommended to remove the status switches for gear and group selection and check their
and check that they are functioning properly. Replace faulty status switches (87585979/87585980).
As a field solution, install two copper washers (part number: 10280060) between the
status switches and the switch cover, and replace the original gasket with rubber insert.(5169544)
The two copper washers fitted provide the additional clearance required so that no new
distance so that a new switch cover does not have to be fitted.
Checkout